1. Motortard


    Good Day Everyone, after around 300 miles I've noticed that my 2021 Rocket 3 is hard to launch from a stop. Almost as if the clutch engages too soon and engine stalls... When 1st test driving it 1st time I didn’t have this problem and while its warming up it drives well… Once its been running...
  2. Jonathan Nikolaisen

    Clutch adlustment

    I need help on the engagement at the bottom of the clutch cable. I had fixed it an now I have nothing again. I am adjusted almost all the way to the bottom of the screw set so now what... Do I move the cable end lower or higher in order for it to engage oroperly?

    Clutch not engaging

    I changed bars out and now my bike will not engage in gears... I need to know how to adjust clutch to allow bike to engage.

    Clutch issues

    Anyone switch bars and have issues with clutch not engaging? How did you fix it short of changing out the whole cable assembley?
  5. Stefan67

    Clutch slip

    Guys I need to pick your brains, ive got a r3r, 2588 ks on the clock..my issue is im getting the clutch slipping badly...but....only when the bike warms up, cold it's no issue but at the moment I'm on the side of the rd waiting for it and me to cool down. I've installed penners unrestricted...
  6. REBLX136

    Clutch Bark

    I’ve noticed a slight bark in the clutch on take off just as it picks up the bite in first, it’s not constant and doesn’t matter if she’s hot or cold, I can feel the bark through the lever and it repeatable but not consistently, shifting isn’t effected. Anyone else experience similar, she has...
  7. Engine dies when clutch pulled in and chnage down

    Hello all I have a 2021 Rocket due for its first service, however I have noticed more than a few times the engine dies when changing down coming up to traffic lights etc, starts no worries, but is a bit of a worry. The bike idles quite well normally. Thanks
  8. Micksan


    I have a 2014 R3T. I just converted it to a trike. The wife rides also. Problem is that the lever setup for the T is set to far out for her hands. She has to take her hand off the handle bars to get at the levers. I have tried every source. No adjustable levers for the "T"s. Lots for the...
  9. Micksan

    HELP>>> Need to find adjustable ,or fixed Brake & Clutch Levers

    The stock levers are to far out from the handlebar. My wife says she can not ride until we can get them in closer. I am 6ft 3 with big hands and find it is a reach for me also. Found out the hard way that the Roadster and touring models have much different levers. Can find for Roadster but...
  10. Thedoctorr

    Clutch Switch Removal

    Hi All This is my 1st rocket in my 23 bikes owned over many many years. I have searched tirelessly through the service manual on how to take out the clutch switch but nothing on how this is done. Can anyone tell me how to do this please. regards Neil
  11. Rocketeer4life

    CLUTCH cable adjustment SEEMINGLY WORST part of engine SWAP!!!??

    hello all. So I've got my pride n joy on the Virge of taking out for a test run after a lengthy and enjoyable engine swap. BUT this step is baffling me after combing over many many threads of this similar/ exact same issue. With following the captains n gurus step by step words of wisdom....haha...
  12. john allenden

    Clutch issue

    Morning guys, My clutch started sticking before I start her up ,if I pull the clutch in in gear and rock it it won't free up. If I start it in gear it pulls a little but frees up. Once riding its smooth but everytime I engage gear from a stop its a hard clunk any ideas ???? And if I start in...
  13. EskimoPie

    Clutch rattle in neutral

    I know this is somewhat of a common phenomenon on bikes, but I haven't seen it mentioned in the 2020+ forums so thought I'd ask. My bike didn't do this new, but now with ~4k miles on the clock, if I come to a stop in neutral with the clutch level released, I get some minor rattle noises from...
  14. Clutch switch problem

    Bike, 2020gt with 10grand, threw an engine code. Was running rough, and would quit coming to a light. Dealer diagnosis said it was clutch switch, which apparently causes the brain to need lobotomization. The clutch switch is located under the clutch lever and is vulnerable to damage from...
  15. oaklandish

    Squeal, knock and grinding noise coming from clutch area

    I started noticing an occasional squeal noise when riding coming from the front end which seemed to start soon after a front tire change. At first I thought it was coming from the tire and took the wheel off to feel the bearings and had my brother ride it in front of the house so I could try to...
  16. Micksan

    Clutch cable scratch my head.

    Some of you may have seen my last bit about clutch cables. That cable was too short. The previous owner had installed a different handlebar. The cable was very hard to pull the clutch lever. Plus he had moved the bottom cam off the alignment marks. I guess to get it to fit. I ordered a 6...
  17. hnkirank76

    BLACK brake lever and clutch lever for 2018 Rocket iii

    I would to add BLACK brake lever and clutch lever for 2018 Rocket iii. Which ones are compatible ? Where can i find them in US ?
  18. Micksan

    Clutch problem solved AT LAST

    I put the bike in the stand and got it up to where it was easy to see things. A bunch of little things added up to a pain in the butt. First of all, I found out the workshop manual I purchased back in Dec is for the 05>07. I call the seller today and no beating around the bush. he will have...
  19. Micksan

    Clutch adjustment driving me up a wall.

    This is on a 2014 Touring. Has about 3100 miles on it. I have been pulling wrenches on my bikes for more than a few decades. The clutch adjustment is supposed to be a very simple task. I have about a hundred miles on it since I purchased it. The clutch has always pulled hard. Decided to put...
  20. Chariot

    Clutch upgrade

    I am looking to upgrade the clutch on my 2016 model. Was there any factory upgrades ?